Stationary Die Change Tables

T-shaped Version with manual Die Movement


Stationary Die Change Tables usually are installed at the rear side of the presses and are built in a T-shape.

This version allows to the operator 

• to deliver in advance by overhead crane or forklift truck the next
  press die to be used and to park it at a parking position on the
  Die Change Table up to the use.
• to pull out of the press the press die which is not any longer used
  and to park it in a parking position on the T-shaped Die Change
  Table up to the time when it will be picked up by overhead crane
  or forklift truck.
• to push the new press die, delivered earlier, out of the parking position
  into the press.
• to pick up the used press die by overhead crane or forklift truck,
  after start up of the newly installed press die.

The complete procedure of die changing herewith can be prepared optimally and can be done within shortest time.

The Die Change Table as a T-shape is equipped with pneumatic operated die lifters with rolls, which do lift the press die ready for transport. The die lifters with rolls are put into T-Slot-Housings which are fixed on top of the T-shaped Die Change Table.They are equipped with big rolls which do allow a very easy manually moving of the press die. At parking position the rolls are lowered and the press die then is standing very solid, protected against rolling away by error. 

In case of manually operated Die Change Tables the press dies are moved manually by the operator. Manual moving of press dies on Die Change Tables qualifies specially for light press dies. The upper limit for manual moving of press dies is flexible. We recommend manual movement of press dies up to maximum 5 tons. 

You would like to optimize your die change procedures?
Please contact us and inform us about your corresponding press die data as well as information regarding installation situation. Together with You we would like to establish a proposal for improvement of press die changing situation. Surely we can transmit to you a very interesting offer.

 
If you will have questions regarding our manually operated T-shaped Die Change Tables, we will be at your disposal for clarification at any time. Please do not hesitate to contact us:   

 

Phone:  +49 2156 419193
Fax:  +49 2156 4979325
Email:  info@seidel-handlingsysteme.de




 

coil_transport_cars_with_carrying_bolt Handlingsysteme feeder straighteners RSDE80 ground conveyors PTT3 carts for coil transport with prism levellers Werkzeugwechsel ultra compact line for strip processing large sized_double_decoiler_with_variable_speed_drive compact strip processing line Werkzeugwechsel pedestrian_push_pull_unit_PTT3_with_pivot_bearing pedestrian_movers_with_lifting_hydraulics